重力插值方法研究     

向文 《大地测量与地球动力学》1997,(2)

为了根据离散观测数据构制连续空间重力变化图像，分析和讨论了３种数值插值方法，计算结果表明多面函数方法插值精度最高。由于逐步回归分析筛选核函数中心点的计算繁琐，文中提出根据分形理论和Ｓｈａｎｎｏｎ取样定理来确定核函数中心点。对滇西试验场进行模拟试算，插值精度可达到４～５（１０－８ｍｓ－２）。  相似文献   

Study on numerical simulation to water lowering in an open coal mine digging     

Yanjun ZHANG Fenglong ZHANG Full QI Fuquan NI 《东北亚地学研究》2006,9(2):199-203

In view of the situation of excavation of open coal mine for the underground water disaster,we should carry out simulation studies for the numerical value of the water lowering project and improve the accuracy and the level of the water lowering project.On the basis of the hydrological geological conditions of certain open mine digging,a more reasonable seepage numerical model was built according to MODFLOW.It was simulated in advance that the process of the confined water level descending with the time,and combining with the actual observations to test the correctness of the model.The calculation showed that the results coincided well with the results of actual measurement.Based on this,different water lowering numerical simulations were built for the open coal mine digging.It could be simulated and forecast that the changes of the groundwater level in drainage process within and outside the mine pit,and it was quantitatively assessed that the possible water lowering result of the opencast water drainage process,which provide an important basis for the actual water lowering project and the possible project disposal.  相似文献   

Upscaling of elastic properties for large scale geomechanical simulations     

F. Chalon  M. Mainguy  P. Longuemare  P. Lemonnier 《国际地质力学数值与分析法杂志》2004,28(11):1105-1119

Large scale geomechanical simulations are being increasingly used to model the compaction of stress dependent reservoirs, predict the long term integrity of under‐ground radioactive waste disposals, and analyse the viability of hot‐dry rock geothermal sites. These large scale simulations require the definition of homogenous mechanical properties for each geomechanical cell whereas the rock properties are expected to vary at a smaller scale. Therefore, this paper proposes a new methodology that makes possible to define the equivalent mechanical properties of the geomechanical cells using the fine scale information given in the geological model. This methodology is implemented on a synthetic reservoir case and two upscaling procedures providing the effective elastic properties of the Hooke's law are tested. The first upscaling procedure is an analytical method for perfectly stratified rock mass, whereas the second procedure computes lower and upper bounds of the equivalent properties with no assumption on the small scale heterogeneity distribution. Both procedures are applied to one geomechanical cell extracted from the reservoir structure. The results show that the analytical and numerical upscaling procedures provide accurate estimations of the effective parameters. Furthermore, a large scale simulation using the homogenized properties of each geomechanical cell calculated with the analytical method demonstrates that the overall behaviour of the reservoir structure is well reproduced for two different loading cases. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

Numerical prediction of blast‐induced stress wave from large‐scale underground explosion     

Chengqing Wu  Yong Lu  Hong Hao 《国际地质力学数值与分析法杂志》2004,28(1):93-109

This paper presents a numerical model for predicting the dynamic response of rock mass subjected to large‐scale underground explosion. The model is calibrated against data obtained from large‐scale field tests. The Hugoniot equation of state for rock mass is adopted to calculate the pressure as a function of mass density. A piecewise linear Drucker–Prager strength criterion including the strain rate effect is employed to model the rock mass behaviour subjected to blast loading. A double scalar damage model accounting for both the compression and tension damage is introduced to simulate the damage zone around the charge chamber caused by blast loading. The model is incorporated into Autodyn3D through its user subroutines. The numerical model is then used to predict the dynamic response of rock mass, in terms of the peak particle velocity (PPV) and peak particle acceleration (PPA) attenuation laws, the damage zone, the particle velocity time histories and their frequency contents for large‐scale underground explosion tests. The computed results are found in good agreement with the field measured data; hence, the proposed model is proven to be adequate for simulating the dynamic response of rock mass subjected to large‐scale underground explosion. Extended numerical analyses indicate that, apart from the charge loading density, the stress wave intensity is also affected, but to a lesser extent, by the charge weight and the charge chamber geometry for large‐scale underground explosions. Copyright © 2004 John Wiley & Sons, Ltd.  相似文献   

A 3D finite element simulation model for TBM tunnelling in soft ground     

Thomas Kasper  Günther Meschke 《国际地质力学数值与分析法杂志》2004,28(14):1441-1460

  相似文献   

武汉区域气象中心数值预报业务并行计算机系统     

龚贤创  范宏飞  余康庆  王宏记 《成都信息工程学院学报》2002,17(4):236-239

对武汉区域气象中心并行计算机系统进行了详细地介绍，分析了并行计算机体系结构、网络和存储系统特点；给出了在并行计算机SP上实现数值预报业务并行化的部分结果；对数值预报模式在串、并行编程环境下的结果进行了分析比较。  相似文献   

Optimization of grid-drilling using computer simulation     

J. William Miller Jr. 《Mathematical Geology》1991,23(2):201-218

A computer simulation method has been developed to find efficient drilling grids for mineral deposits. A well-known ore deposit is used as a model to develop an efficient pattern for undiscovered ore bodies in the same area or in other prospects where similar geometry is suspected. The model for this study is the Austinville, Virginia deposit, a Mississippi Valley-type deposit composed of 17 ore bodies totaling 34 million short tons (30 million metric tons). The method employs a computer program that simulates drilling the model deposit with different patterns, including various levels of follow-up drilling. Follow-up holes are drilled in fences at one half the original spacing around holes in the grid that show ore-grade mineralization. Each pattern is drilled 100 times from random starting locations to provide a range of outcomes of drilling, including the best, worst, and most likely. For this study, patterns of 100 drill holes were composed of 10 fences spaced 1000–5000 feet (305–1524 m) apart, each with 10 holes spaced 200–1000 feet (61–305 m) apart. In all, 25 grids were used with zero to three levels of follow-up drilling. The 600/2000 grid, with drill holes spaced 600 feet (183 m) apart in fences spaced 2000 feet (610 m) apart, was compared with the 200/5000 grid because they represented contrasting outcomes. The 600/2000 grid penetrated many ore bodies consistently but with few multiple hits to individual ore bodies; whereas the 200/5000 grid inconsistently penetrated few ore bodies with many multiple hits. The 600/2000 grid was more efficient than the 200/5000 grid at hitting large ore bodies of 1,000,000 short tons or greater (900,000 metric tons or greater) and was made more effective by adding one cycle of follow-up drilling. The 600/2000 grid had a 97% chance of hitting one or more large ore bodies with at least one drill hole per ore body, and the 200/5000 grid had a 64% chance. Once hit, there was an 82% chance that the largest ore body would be penetrated by three or more holes when using the 600/2000 grid and an 88% chance using the 200/5000 grid.  相似文献   

基于CTI技术的守时系统故障报警实现   总被引：2，自引：0，他引：2  

蔡成林  董绍武 《时间频率学报》2003,26(2):103-110

介绍了计算机电话集成(CTI-Computer Telephony Integration)技术在守时系统故障自动报警中的应用。简要介绍了构成报警系统的两个关键产品，电话语音卡和TTS(Text-To-Speech)，详细讨论了ActiveX控件(Phonic．OCX)编程接口的一系列事件和方法以及由此而开发的故障报警模块。该模块不仅用于守时主系统的故障报警，也将用于电源系统、钟房环境监控系统的故障报警。  相似文献   

介质横向不均匀对震后地表位移场的影响     

朱桂芝  王庆良  李辉  唐文 《大地测量与地球动力学》2003,23(4):54-59

利用三维有限元模拟两层地球模型(包括弹性层和粘弹性层)介质的横向不均匀和断层错动的复杂性对震后地表位移场的影响，其数值结果包括弹性解和粘弹性解。结果表明，震后位移场的分布特征不仅与粘弹性层的流变特性有关，还与弹性层介质的剪切模量以及断层的同震错动有关。  相似文献   

海拉尔盆地乌尔逊凹陷古流体动力场数值模拟   总被引：5，自引：0，他引：5  

杨金侠 《地球科学与环境学报》2003,25(3):41-47

首先对地下水动力场进行数学描述,以水动力为主线,建立适合该地区的数学模型,选择正确的地质模型参数,主要采用数值计算和模拟等手段,在恢复出乌尔逊凹陷主要目的层在不同地质历史时期古水动力的基础上又恢复出古流体势的演化历史。整体上,在乌尔逊凹陷,各主要地质时期的油势演化特征为西部地区大于东部地区,乌南大于乌北,且低势区的发育有较好的继承性。最后,依据油气聚集理论,进行油气运移聚集系统的划分、油气运移方向的分析,从而得出有关研究区油气运移聚集条件的认识,主要从流体动力的角度考虑,指出有利聚集区,认为在乌尔逊凹陷苏4～苏18井区、苏132～苏17～铜2井区及巴1～巴2～巴4井区为有利油气运移聚集区。  相似文献